Joho - Cargear 50x300cm blue vlt70% window tinting foil for car side window, heat block irr97% glass tint solar protection ceramics pet film

Hign-concerned chemical : none position : side windshield special features : solar protection material type : pet item weight : 0.

18kg item width : 50cm item length : 300cm color name : blue model name : f607-c70 window foils type : side window solar protection transmittance : 60%-80% heat insulation rate : 80%-100% ultraviolet blocking rate : 80%-100% origin : mainland china item type : window foils & solar protection read before you buy!!! --- ** if you see any creases from unrolling the roll, this would not affect the item when you apply to your car! we are not responsible for creases from unrolling the roll because that is the nature of the roll when you unroll the item or when the item rolled for too long (think about when you fold your clothes for a long time, it will have crease/wrinkles)** tinted windows are becoming increasingly popular with drivers everywhere - and whether you want them for the additional privacy they offer, the protection they give from blazing heat and harmful uv rays, or simply the sleek, polished look they give to your car, its always an option to tint your side windows yourself.

although tinting car windows can be a difficult task for beginners, the following steps will help facilitate the process, and allow you to give your vehicle a fresh new look.

film tinting is a very popular method for tinting car windows after theyve been purchased.

with this method, the window glass first needs to be specially treated, before a thin polymer film is carefully attached to the glass.

this is probably the least expensive form of window tinting, and some installers believe that the film can even limit the possibility of the windows shattering upon collision.

however, film tinting is not permanent and it will need to be replaced every five years or so to prevent cracking, peeling, and bubbling.

consider having your film tint applied by a professional installer if you have never applied film tint before.

this way, you can avoid the appearance of bubbles or damage to the film.

instructions:step 1.

measure the size of the car glass, the length and width of each one plus more than 3 cm, so as not to install the film does not conform to size.

step 2.

a clean window is vital a successful factor,so keep window or glass clean.

step 3.

remove the transparent backing sheet from film.

cover the surface of the whole film with water.

this helps to prevent the film becoming tangled and sticking to itself.

step 4.

pick your film up and apply to your window( please make sure you have removed the backing sheet before you apply to the window and glass).

soap and water on film and glass can make it slide to the correct position.

step 5.

and repeat scraper process,using the scraper to push any remaining moisture or bubbles to the edge of the window.

much easier than wall decals.

step 6.

finally use the paper towels to dry the window and the frame,being carefully not to lift the film at the edges or corners.

note: 1.

before installing , please check the film carefully,if you find any creases,tears or other defects,please contact us immediately for advice.

don’t remove the backing sheet or attempt to fit your film.

we are unable to accept returns or provide refunds if installation has been attempted.

if you want other size, please contact us.

specification: 1.

material: pet 2.

size:0.

5*3m 3.

vlt transmittance rate:70% 4.

uvr heat insulation : 99.

irr: 95% 6.

thickness: 2mil.